Drain & Refill Engine Oil. Replace engine oil filter. Lube all greaseable joints. Refill with Full Synthetic oil up to 5 qts. Check all other fluid levels under hood. Perform 25 point visual safety inspection.
Paula B. gave our service a 5 star review on 4/7/2023
Drain & Refill Engine Oil. Replace engine oil filter. Lube all greaseable joints. Refill with Full Synthetic oil up to 5 qts. Check all other fluid levels under hood. Perform 25 point visual safety inspection.
N.J. State Inspection Pass or Fail
Maria C. gave our service a 5 star review on 3/30/2023
Drain & Refill Engine Oil. Replace engine oil filter. Lube all greaseable joints. Refill with Full Synthetic oil up to 5 qts. Check all other fluid levels under hood. Perform 25 point visual safety inspection.
Road test vehicle & inspect front end suspension. Found LF axle shaft causing noise on turns & RR wheel bearings loose / noisy.
WHEEL BEARING – Remove & Replace – Rear,One Side Passenger Rear – [DOES NOT include wheel alignment.] – [Includes: Replace Seals (where applicable).]
Scott W. gave our service a 5 star review on 3/22/2023
Lubricate chassis if vehicle has grease fittings. Change engine oil and oil filter. Check air filter. Check all fluid levels under hood and tire pressures. Perform 25 point visual safety inspection. Replace up to 5 qts of Oil.
Dan T. gave our service a 5 star review on 3/21/2023
Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( 85%) Rear ( 75%) Torque wheels to factory specs. Found RR brake caliper frozen causing brakes to drag, and E brake hardware & backing plates rusted out requiring replacement.
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Lubricate chassis if vehicle has grease fittings. Change engine oil and oil filter. Check air filter. Check all fluid levels under hood and tire pressures. Perform 25 point visual safety inspection. Replace up to 5 qts of Oil.
Mike S. gave our service a 5 star review on 3/6/2023
Road test vehicle to verify customers complaint. Determine cause of vibration. Advised customer front brake rotors are warped causing vibration during braking. Front universal joint on driveshaft is loose / binding up causing vibration of customers complaint. Advised customer that u joints are Not serviceable & complete driveshaft requires replacement. Customer declined replacing front brake rotors at this time.
PROPELLER SHAFT – Removal & Installation
Pete W. gave our service a 5 star review on 2/14/2023